- Home /
- Power Generation & Management /
- Solar /
- Solar Panels /
- Sunware Sprayhood Solar Panels
Shop Now
- Batteries
- Boat Hardware
- Comfort
-
Electrical
- Battery Switch
- Busbars, Terminals & Insulators
- Cable Management
- Circuit Breakers
- Deck Seals
- Electrical Panels
- Electrolysis Protection
- Engine Instruments
- Fuses & Fuse Blocks
- Heat Shrink
- Horns
- Meters
- Plugs & Sockets
- Single & Multi-Core Cables
- Switches
- Terminals & Crimps
- Tank Senders
- Accessories, Upgrades & Spares
-
Marine Electronics & Raymarine
- Element Hv
- Antennas
- Autopilots
- Axiom Range
- Digital Switching
- Electronic Charts
- Element Series
- Fishfinder/Sonar Modules
- Instruments
- Marine AIS Devices
- Marine Cameras
- Mounting Systems
- Networking & Cables
- NMEA Converters & Sensors
- Radar
- Satellite TV
- Thermal Cameras
- Transducers
- VHF Radios
- Accessories, Upgrades & Spares
- Marine Lighting
- Power Generation & Management
- Propulsion & Around The Engine
- Pumps
- Safety Solutions
- Sanitation & Tanks
- Steering Control & Trim
- Tenders & Inflatables
- Vessel Manoeuvring Systems
- Watermakers
- Winches & Cranes
Sunware Sprayhood Solar Panels
Sunware Solar Panel Spray hood solutions
The sprayhood on board is permanently installed on almost all boats and offers an excellent place for solar panels to cover the electricity requirements. Since the tree almost always shades the middle area of the sprayhood, smaller powerful TX modules on the right or left edge of the sprayhood are suitable. The central area directly below the boom remains free. Such a sprayhood solution supplies enough electricity, for example, to be able to operate the compressor refrigerator permanently.
The modules are offered with cable outlets on the left and right (for port/starboard) so that the cables can be led down as elegantly as possible. On larger yachts, the larger TX modules often fit on the spray hood, so that more charging power is available when consumption is high.
Included with each single panel:
- 6 LOXX bases with wrench
- Sealing washers for the LOXX lower parts
- 8mm punch for punching out the holes for the LOXX elements in the sprayhood
- 1m double-sided fleece/velcro tape for attaching cables to the sprayhood rods.