- Home /
- Power Generation & Management /
- Charge & Convert /
- Chargers /
- Sterling 12V to 12V DC to DC Battery Charger
Shop Now
- Batteries
- Boat Hardware
- Comfort
-
Electrical
- Battery Switch
- Busbars, Terminals & Insulators
- Cable Management
- Circuit Breakers
- Deck Seals
- Electrical Panels
- Electrolysis Protection
- Engine Instruments
- Fuses & Fuse Blocks
- Heat Shrink
- Horns
- Meters
- Plugs & Sockets
- Single & Multi-Core Cables
- Switches
- Terminals & Crimps
- Tank Senders
- Accessories, Upgrades & Spares
-
Marine Electronics & Raymarine
- Antennas
- Autopilots
- Axiom Range
- Digital Switching
- Electronic Charts
- Element Series
- Fishfinder/Sonar Modules
- Instruments
- Marine AIS Devices
- Marine Cameras
- Mounting Systems
- Networking & Cables
- NMEA Converters & Sensors
- Radar
- Satellite TV
- Thermal Cameras
- Transducers
- VHF Radios
- Accessories, Upgrades & Spares
- Marine Lighting
- Power Generation & Management
- Propulsion & Around The Engine
- Pumps
- Safety Solutions
- Sanitation & Tanks
- Steering Control & Trim
- Tenders & Inflatables
- Vessel Manoeuvring Systems
- Watermakers
- Winches & Cranes
Sterling 12V to 12V DC to DC Battery Charger
Buck Boost design, offering high efficiency (95-98%). Simple installation and setup. Current limiting charger. Lithium safe.
Smart Alternator/Euro 6+ compatible. Ignition feed or Vibration Sense modes. 6 pre-set battery types. 6 self-recovering protections. Low temperature trip for Lithium Ion batteries.
EV - Electric Vehicle Compatibility - 3 reasons to install a BB instead of direct cabling / relay: Underneath the bonnet of EVs is the positive and negative 12V terminal that leads from the high V -> low V DC DC converter to the 12V battery. There is usually a 12V positive busbar and a 0V negative post. One of these positive feeds leads to the 12V battery. The 12V post that leads to the 12V battery would be where you install the BB along with the common negative post. The high voltage to low voltage DC DC converter shall likely be itself current limiting. However, the vehicle has uses for this current, albeit, not all of this current all of the time.
The Sterling 12V to 12V DC to DC battery charger is able to charge in both directions. Provided there is over 13.2V on the leisure battery (13.5V if lithium) and the starter battery is below 13V the BB shall allow approximately half current (~20A) to flow back to the starter battery up to about 13.4V (float voltage). It simply allows the starter battery to remain topped up when there is surplus energy in the domestic battery. This feature will NOT drain your domestic battery - it simply takes surplus. Once your alternator / engine turns on or you provide the BB with an ignition signal the BB reverts to normal charging of the leisure battery. This mode can be disabled, but is on as default.
This is ideal for allowing the starter battery to remain topped up when you have solar / wind / charger - charging up your leisure battery.
Related Products
-
12-24VDC, 30A 2022 ModelBBW122430RRP:$852.00 Incl. GST
-
120A input, Bidirectional with reverse charging and jump start assistance mode, 1620W output powerBB12120RRP:$1,945.00 Incl. GST
-
40A input - Bidirectional with reverse charging and jump start assistance mode, 550W output powerBB1240RRP:$862.00 Incl. GST